×

LED DRIVER III

Constant output voltage 24V LED Driver.
Universal input voltage range 85~265 AC .
Push terminals for simple wiring.
Nominal life-time up to 50,000 h (at ta 65 °C with a failure rate ≤ 0.2 % per 1,000 h)
Suitable for emergency escape lighting systems acc.

Objective :

This product should be installed by qualified personnel. IP67 of this product, can be installed outdoors and can not working in water for a long time. Good heat dissipation conditions extend product life. Please install the product in a well-ventilated environment. Please check whether the output voltage and current of the LED driver meet the requirements of product. Due to safety concerns, PVC or rubber cord of 0.75-1.5mm² is recommended for input and output terminals (excluding signal terminals).Ensure all wire connections right. Avoid overheating and poor contact cause accidents Flat power cord is not suitable. Ensure all wire connections and polarities are correct before applying power to avoid any damages to the LED lights. In case of malfunction, do not repair it your self: If in doubt, please contact the supplier.

Technical Information :

Code:

Wattage:

Documents:

Copyright 2020~2021 Roma Luce All Rights Reserved - Trade Mark registered